FYSETC / FYSETC-SPIDER

FYSETC Board - 3d printer motherboard for VORON and other open source project.

311 stars 148 forks source link

No Fan1, Pin PB2. No fans on startup. #95

Closed mgeorgeHome99 closed 2 years ago

mgeorgeHome99 commented 2 years ago

I seem to have a problem out of the box with my Spider V2.2, the Controller fans x2 wired to Fan1 do not run initially nor when I hit bed temp. Their is also no LED on associated with the port like the other fans.. The other fans run on startup fine and have an LED, this seems to be a problem since setup. Config below,

[heater_fan controller_fan]

Controller fan - FAN2 Connector

pin: PB2

kick_start_time: 0.5

heater: heater_bed heater_temp: 45.0

mgeorgeHome99 commented 2 years ago

I noted on a subsequent power cycle that the red LED started to come on, maybe the jumper was loose?? Regardless, the enclosure fans now work.