FYSETC Vorn SB CAN Toolhead V1.3

[solrac8874]

Where can I find installation, schematics, etc. V1.3 version of this tool head? I tried installing it using the Fystec SB CAN Toolhead Wiki (https://wiki.fysetc.com/SB%20CAN%20ToolHead/#31-menuconfig). But when following 3.2 Firmware Upload step 4: Plug in SB-CAN-TH board 24v socket to power on it( Get the power from machine PSU); the Vin Fuse popped. Now the board no longer powers on.

The wiki page and github site for the Fystec SB CAN Tool Head is only for V1.1 of the board and have not be updated for V1.3. Seems like my board was fried from following the V1.1 Wiki Instructions.

[Interfredzo]

Can confirm this!!!!!

Following all steps destroys the board after flashing!!!

[eliwong]

We already updated the wiki. Please check!

[solrac8874]

Thanks. I wish the wiki and github were updated several months ago before I bought the CAN Toolhead board in September 2023 or when V1.3 was released.

The wiki & github should have or include pictures of the V1.3 board front & back. Also maybe helpful to highlight the differences between V1.1 & V1.3 board (e.g. different specs, components, etc.) like the Amazon product page describes.

Is the Vin Fuse (F1 - 5A) part shown on the V1.3 schematic/position diagrams the same as the Vin Fuse (F1 - ASMD1206-300) part shown on the V1.1 schematic/position diagrams? The V1.3 schematic doesn't show the fuse part number like the V1.1 schematic. Are there any other components besides the fuse that are different and potentially at risk of being damaged by following the original V1.1 instructions?

I'm hoping I can just replace the Vin Fuse and get the V1.3 board working again so I can try to follow the new V1.3 instructions and confirm the new updates work.

[Interfredzo]

The TMC2209 might be damaged.

I've also noticed that JP3 and R18 are actually missing on the board:

[solrac8874]

R18 and JP3 are missing from my board too... hope that's not a mistake. Seems R18 and JP3 trace to CANL and CANH.