GPS sensor is NOT working on this latest PCB.

FabienFerrero / UCA_Board

Gerber Layout of the UCA board

35 stars 14 forks source link

GPS sensor is NOT working on this latest PCB. #5

Open ethicstechOSS opened 6 years ago

ethicstechOSS commented 6 years ago

Hi. I got your latest version of PCB and testing CPham's GPS Collar project, https://github.com/CongducPham/tutorials/blob/master/Low-cost-LoRa-Collar.pdf But I am not receiving any GPS datas at gateway side. I also realized that the PCB board he used on his document/experiment and your current PCB might have some differences. Kindly share the schematic document for current version of PCB.

Also like to know if you had tried GPS sensor (GPS collar project expected to work straightaway) on your latest version of PCB.

TIA.

FabienFerrero commented 6 years ago

Hi Tia,

Personaly I don't try this tutorial, but I know that CongDuc Pham has tested it.

There is one mistake in this PCB version, the RAW pads are connected to the wrong pin of the Arduino (the reset pin). So if you use the raw input, you have to connect directly to the pin below the Arduino raw pin.

As shown in this picture :

Sorry for the inconveniance

Fabien