Test hope rf95 - Githubissues

FabienFerrero / UCA_Board

Gerber Layout of the UCA board

35 stars 14 forks source link

Open lbauchwitz opened 5 years ago

lbauchwitz commented 5 years ago

At least, i do not solder in pcb. I try to test in protoboard, but rf95 not respond. How can i sure the module is ok?

FabienFerrero commented 5 years ago

The easyest test, is to run the continuous wave code. Look on the serial monitor with 38400 baud rate, it will tell if the module is detected.

Fabien