Closed kb1lqc closed 7 years ago
FD2 on top layer bottom left is the origin of all parts on the board. Its XY coordinate is 0,0!
FD1 on Top Layer and FD6 on Bottom layer are offset from each other. This allows you to know absolutely if you are measuring fiducials on the top layer or on the bottom layer.
Mousebites are clearly on all four sides of the PCB. The copper pours and all traces are pulled back out of the danger area near the tabs were cutting through the NPTH's can cause traces to crack. These mousebites are circled in red.
The fiducials are circled in orange and are on the bottom left, bottom right, and top right corners of the top layer. Fiducials on the bottom are located on the bottom left, bottom right and top left corners of the PCB.
The ECO2 layer of the Faraday PCB design clearly documents the intended path of a 100 mil routing bit to cut out each PCB from a panel.
Check that locations are correct and make sense. PCB:NG may not need mousebites predefined but it helps them even if they don't use my exact design.