Closed Sh1n1x closed 6 years ago
Did you make a fresh install (flashed 0099, installed hack, updated to 0154) or you were previously on 0147 with working hack and updated to 0154 ?
I have made a fresh install with flash of 0099, install hack and update to 0154.
I was on 0147 hacked, and I have lost the hack (ssh Access) after update to 0154. Any suggestions to recover the hack?
@willthrom what do you recon we should do?
I haven´t had time to reproduce the issue but I would say to @vija24 to follow the procedure from the beginning, like you, @ferdydek , explain very accurate last time, meaning, reflashing to .99 and start over.
@Sh1n1x @vija24 can you pls comment back if you managed to get it sorted?
I can confirm it here too.
Flashing the tf_recovery.img
works and downgrades back to 0099.
SSH and RTSP works perfectly, so is the app stream being disabled.
However, as I upgrade to 0154 the hack can no longer be applied.
I've tried multiple times the whole procedure:
I've also tried using version 7.1 of the hack with no success.
@Sh1n1x , @vija24 I'll be happy to get the steps to make this work over 0154, until then I'll have to use version 0099.
@sagilo for me nothing is working for the moment, this camera isn't hacked :/
Thank you @Sh1n1x, I use the hack with version 0099 for now.. hopefully it will be fixed and I'll be able to upgrade my camera firmware
not works
When somoone with an UART-Serial adaptor open its camera and read the logs I will be able to resolve this issue.
(I tried with mine but my soldering iron was in a very bad state and the result was the Tx Pin pulled out. Not I cannot read the logs any more)
solutions?
Any suggestions ? this is still relevant for firmware 0158 with latest version (0.8.6)
just try over downgrading to 99 with 0.8.6.
In any case, the steps are just.. downgrade to 99. with the latest release, test SSH there (or check if the camera led blinks orange/blue for 5s at boot time) then upgrade to latest version check SSH again and then change MIDGARD.ini to enable RTSP
Tried that more than 10 times, this doesn't work. More users reproted the same over the chat. I guess this isn't going to be fixed. Thank you for your efforts
what is not working? Is ssh working when downgrading to 99? Is ssh working when upgrading to 158?
Try with downgrading to 99 and upgrading to 158 with 0.8.5
Here is my latest log file