Open bobjimman opened 7 months ago
My best advice is to try to use all the exact versions of the IDE and libraries as specified in the setup guide - basically, copy my exact setup. If you did that, and you set up the flash size, then I'm not sure what else to try. Can you upload the full log of what you're seeing, like this?
My best advice is to try to use all the exact versions of the IDE and libraries as specified in the setup guide - basically, copy my exact setup. If you did that, and you set up the flash size, then I'm not sure what else to try. Can you upload the full log of what you're seeing, like this?
with your advise I went throgh the prodcedure agaian an success. Not such what was wrong all the other times but it works. Thanks for your reply and this project.
Installing Amulet of Entropy followed instructions here for Little FS and Arduino says " LittleFS Create Failed!"
I've reset my computer to factory setting Install Arduino v1 set preference to earlphilhower... tools - board - raspberry pi pico, set port continued to follow instruction for LittleFS install in tools and data
any advise would be appreciated
Thanks