What steps will reproduce the problem?
1. Create a cube 4mm wide
2. Select 2 opposite edges on same side
3. Set fillet to "2"
4. Error occurs
5. Reduce to 2-x, where x is a small value
6. Fillet works properly
What is the expected output? What do you see instead?
I would expect the fillet operation to work for an exact value like both sides
of something, as above. (Obviously I would expect it to fail for values greater
than 2 in this case.)
What version of the product are you using? On what operating system?
Win XP, HeeksCAD 0.14.0
Original issue reported on code.google.com by adwo...@discreetsecuritysolutions.com on 17 Nov 2010 at 9:01
Original issue reported on code.google.com by
adwo...@discreetsecuritysolutions.comon 17 Nov 2010 at 9:01