First layer already has weird zigzags

FormerLurker / ArcWelderLib

A collection of projects used to convert G0/G1 commands to G2/G3 commands.

365 stars 39 forks source link

First layer already has weird zigzags #77

Open docwilco opened 3 years ago

docwilco commented 3 years ago

I'm not sure what the best way to report these is, but I made a body that has what should be very close to straight lines, but after an AW pass, the printer makes very weird zigzags on the first layer. I use AW straight from Cura, so not sure what to provide other than the 2 GCode files, which I have attached.

I didn't print past the first layer, because I didn't want to waste filament.

arcweld_problem_docwilco.zip

docwilco commented 3 years ago

FYI, all my other prints with AW enabled have been going just fine! This was the only print so far that this happened with.