A plugin for OctoPrint used to convert G0/G1 commands to G2/G3 commands. Reduce the size of your gcode files, and reduce number of gcodes per second sent to your printer.
I'm not sure if this is really an issue, but if I'm reading this correctly, it would appear that the plugin has a pretty poor understanding of large arcs and their optimization path?
This is the only print I've seen it happen to this degree on, and it didn't cause an issue, but perhaps raising this might lead to more across-the-board optimizations. Or it could be that I'm simply misunderstanding the information I'm seeing.
(Ignore the lethargic print time, recently discovered my extruder motor gear is wearing out so it's slow to compensate for backlash during replacement period, lol)
I'm not sure if this is really an issue, but if I'm reading this correctly, it would appear that the plugin has a pretty poor understanding of large arcs and their optimization path?
This is the only print I've seen it happen to this degree on, and it didn't cause an issue, but perhaps raising this might lead to more across-the-board optimizations. Or it could be that I'm simply misunderstanding the information I'm seeing.
(Ignore the lethargic print time, recently discovered my extruder motor gear is wearing out so it's slow to compensate for backlash during replacement period, lol)
The model causing the issue, nothing extremely unusual in PrusaSlicer 2.3.0 Vent Director Master.Body.zip
(Renamed to .txt so github would accept it, don't have the original but can reproduce) Vent_Director_Master.Body.aw.gcode.txt