Open madmic1314 opened 2 years ago
Couple of information gathering questions.
What's your printer model? What firmware version is it?
Do you have dynamic precision turned on for Arc Welder?
Hypothesis I'll bet those straight edges have longer length arc commands that are causing truncation of the commands when sent to the printer planner. An update to the firmware and an increase to possible command length is needed for best arc compatibility. But this is just an hypothesis.
On Mon, Apr 18, 2022 at 3:26 PM madmic1314 @.***> wrote:
Have found the strange layer shift issue (#113 https://github.com/FormerLurker/ArcWelderPlugin/issues/113) when models have a straight edge - most noticeable with shelf brackets.
Using Cura plug-in and also Octoprint plug-in - both seem to do the same. If I process with the octo plug-in then download the gcode you can see the layer shift present. Seems to be along the layers which have the screw holes in.
— Reply to this email directly, view it on GitHub https://github.com/FormerLurker/ArcWelderPlugin/issues/228, or unsubscribe https://github.com/notifications/unsubscribe-auth/AE5J4UALIOANSJSEGM4EWQTVFWZM3ANCNFSM5TWUU7UA . You are receiving this because you are subscribed to this thread.Message ID: @.***>
Thanks - Printer is BTT SKR 1.4 running marlin 2.0.9.3.
Attached is an example of AW in Octo - the arcswelded file as .aw in the name. You can see where the screw holes are there is a difference (know Cura can't show arc gcode yet).
Have found the strange layer shift issue (https://github.com/FormerLurker/ArcWelderPlugin/issues/113) when models have a straight edge - most noticeable with shelf brackets.
Using Cura plug-in and also Octoprint plug-in - both seem to do the same. If I process with the octo plug-in then download the gcode you can see the layer shift present. Seems to be along the layers which have the screw holes in.