I have a Kingroon KP3s and when I run Octolapse, the extruder moves in overdrive and pushes out way too much filament and then on the first layer it will stop moving and just extrude a huge pile until I stop it. If I disable Octolapse, it prints just fine.
I have a Kingroon KP3s and when I run Octolapse, the extruder moves in overdrive and pushes out way too much filament and then on the first layer it will stop moving and just extrude a huge pile until I stop it. If I disable Octolapse, it prints just fine.
I'm totally lost and can't figure it out.