FILAMENT SENSOR AND POWERLOSS RECOVERY NO WORK

[matiasdj87]

Did you test the latest bugfix-2.1.x code?

Yes, and the problem still exists.

Bug Description

FILAMENT SENSOR NOT WORK and POWERLOSS RECOVERY NOT WORK.... with SCWTPULR-Robin_mini.bin STOCK FIRMWARE... but with QQS Repetier Firmware its works fine. M412 is ON and M119 is tiggered or open if the filament is charged or no..

Bug Timeline

No response

Expected behavior

No response

Actual behavior

No response

Steps to Reproduce

No response

Version of Marlin Firmware

2.1.2

Printer model

FLSUN QQS PRO

Electronics

MKS ROBIN MINI

Add-ons

No response

Bed Leveling

UBL Bilinear mesh

Your Slicer

Simplify3D

Host Software

SD Card (headless)

Don't forget to include

• [X] A ZIP file containing your Configuration.h and Configuration_adv.h.

Additional information & file uploads

No response

[Foxies-CSTL]

Hi, These two options are available via the "Configuation" menu ("Runout" and "power_Outage") and you need to activate them (toogle button) and then save their position by saving settings (configuation menu). Note: Power_Outage" works only with SD_card print. No with Host print.

[cpeg78]

Hello, when I turn on runout, the printer is stopping and wants to change filament. Filament was correctly loaded and sensor light is blue.

[Foxies-CSTL]

when I turn on runout, the printer is stopping and wants to change filament. Filament was correctly loaded and sensor light is blue.

Hi, You can check the correct operation of the filament sensor with the M119 command, which will give you an indication of the ON/OFF status in the terminal.

If you don't have the "TRIGGERED" state when the filament is inserted, then you've got reverse detection.

[cpeg78]

Hi,thanks for your answer. Is it possible to change the detection? On my Ender 3 V2, I can change it from High to Low, but can‘t find such setting on my Q5.Am 30.08.2023 um 16:36 schrieb Foxies @.***>:

when I turn on runout, the printer is stopping and wants to change filament. Filament was correctly loaded and sensor light is blue.

Hi, You can check the correct operation of the filament sensor with the M119 command, which will give you an instantiation of the ON/OFF status in the terminal.

If you don't have the "TRIGGERED" state when the filament is inserted, then you've got reverse detection.

—Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you commented.Message ID: @.***>

[Foxies-CSTL]

Is it possible to change the detection?

Yes, this is possible in the firmware, but it may be easier to invert the wires if you have a 2-wire detector: 1 wire for signal and 1 wire for ground.

[Foxies-CSTL]

I can change it from High to Low, but can‘t find such setting on my Q5

Yes here in the "Configuration.h" file

[cpeg78]

I already had this idea. Its a cheap on from ebay, with 3 wires.

[Foxies-CSTL]

I already had this idea. Its a cheap on from ebay, with 3 wires.

I answered earlier for configuration.h file ;-)