Open J14111 opened 11 months ago
Hi @J14111 , Calibrating the screen isn't easy with your fingers ;-) For my part, I use a stylus or pen cap to be precise, tapping the center of the cross. If it doesn't work the first time, switch off your printer and try again.
Thanks i will try that next time, in the end i built my own from your files and marlin, it worked first time
Did you test the latest
bugfix-2.1.x
code?Yes, and the problem still exists.
Bug Description
Hi,
Thanks for the great work, I have just upgraded to the latest version, I have a QQS-PRO using the TM9 prebuilt bin file it flashes fine.
I am prompted to calibrate the screen which I do, top left, bottom left, top right, bottom right but after this it goes back to top left but there is also a cross in the bottom right and I cant press anywhere it gets stuck on this screen?
Bug Timeline
new 2.1 was fine
Expected behavior
expect to get past LCD calibration
Actual behavior
Stuck on LCD calibration
Steps to Reproduce
Version of Marlin Firmware
2.1.2
Printer model
QQS Pro
Electronics
stock
Add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None
Don't forget to include
Configuration.h
andConfiguration_adv.h
.Additional information & file uploads
none