Open i3dm opened 1 week ago
It will change, but takes a LOT of spinning the dial. The steps are still in pascals and the unit is being translated for display only
Sorry but this makes no sense for it to be this way. I think it should be rectified.
Which is why #2589 is still open
Yes. Quite an old bug. Shall I close this issue then?
Yes, as it is a duplicate.
X10S checked on 1.4.15 and 1.5.9 - same result. air pressure sensor, default units Pa - made a LS A<X - all ok. changed sensor unit to PSI - made a LS A<X - value is stuck at 0PSI and will not change.