search

FrSkyRC / ETHOS-Feedback-Community

Feedback & suggestions are welcomed here for ETHOS by FrSky
187 stars 84 forks source link

F-Port sensor data does not work with the FLVS sensor #4435

Closed Halfduplex85 closed 3 weeks ago

Halfduplex85 commented 3 weeks ago

Hi I have had the problem for a while that I do not get sensor data with a FLVS voltage sensor over F-port protocol, if I convert this to S-port in the receiver settings then everything works normally and without problems.

I have this problem with all Frsky Archer receivers and multiple firmware versions on the receiver as the transmitter. I am currently running the new firmware on both the receiver and the transmitter.

Transmitter: Firmware version: 1.5.13 EU Bootloader Version: 1.5.0 Module version: 1.1.14 Audio English: 1.5.7 System Bitmaps: 1.5.10

Receiver R6, R8-Pro and R10-Pro Firmware version: 2.1.14

I had this problem with my previous transmitter X20 and now my current transmitter X20 Pro AW.

Satcomix commented 3 weeks ago

Hello Halfduplex85, You must set the receiver from S.PORT to FBUS not F.PORT. The FrSky FLVS is compatible with FBUS/S.Port protocol. Look at the specifikations. https://www.frsky-rc.com/product/flvs-adv/ With FBUS the FLVS Lipo sensor works fine with my X20Pro or X20S best regards, Torsten

mawzthefinn commented 3 weeks ago

F.port is not supported by any FrSky sensor.

older sensors support s.port, ADV sensors support s.port and FBus.

f.port is a deprecated protocol supported only for legacy FC use.