search

FrSkyRC / ETHOS-Feedback-Community

Feedback & suggestions are welcomed here for ETHOS by FrSky
188 stars 85 forks source link

How do I..... Slow up and down only once #4577

Open drummaker opened 1 week ago

drummaker commented 1 week ago

I am putting servo settings to snap roll on a the momentary switch. I did this by creating a flight mode activated by this switch. I created a mix for rudder elevator and ailerons with a 2 point curve both points plus 100 then weight of either plus or minus water I want to snap.

This works great BUT, I decided I would try. And compensate for the fact that ailerons servos are slower than rudder and ailerons. I added slow up and slow down to those mix's to make them slower. This works once only.

I cannot for the life of me figure out how you intend for us to do this, and I do not understand why this only works once..... Can u help me?

drummaker commented 1 week ago

Never mind. This works with a logistics switch.... Why?

spoke2570 commented 1 week ago

This would be a good item to bring to the RCGroups thread.

I am not actually sure why it does it even once with that setup. if the control path jumps from one curve to another with a flight mode switch there is no path to slow. It is disconnected from one path and reconnected to another path somewhere else and the servo speed is the only thing that can govern the time to get there.

There are a bunch of pattern people over there, so I am sure this has been covered somewhere.