search

FrSkyRC / RF_Feedback_Group

Regarding to the RF issues.
0 stars 0 forks source link

RB25s does not switch into automatic mode in case of failsafe , channel 14 = -100% #26

Open Kreisflieger opened 7 months ago

Kreisflieger commented 7 months ago

I am using a RB25S in Quick-Mode with an Archer Plus R8 connected via FBus. I use a X18SE with Ethos 1.5.3. Firmware of RB25S, Archer Plus R8 and RB25-LUAS are all on latest versions. To setup stabilization I set channel 13 (gain) on a pot and channel 14 (stab-mode) on a switch. Everything works fine in Stabilization and Automatic Mode, as expected.

Now I want to activate automatic mode when the receiver goes into failsafe. Therefore I set channel 14 in the LUA config page 3/3 (failsafe settings) to -100%. Gain is set to 70% ( appr. 1750 micro sec. ) This should activate automatic mode with a good gain setting. Unfortunately, the RB25S does not switch to automatic mode when receiver is in failsafe.

Checking the servo output of the RB25S on channel 14, it is switched to -100% which equals automatic mode. But the RB25S is still in stabilization “off mode”. I also set the receiver channel 14 to -100%. No success, either. So I assume that there is a missing logical connection somewhere in the setup: Ethos, config LUA or RB25 firmware. As known, all current S-receivers switch into automatic mode, if failsafe on channel 14 is set to -100%. Why not the RB25S ??

Kind regards

mawzthefinn commented 6 months ago

Confirmed, issue is firmware on the RB25S and RB35S, failsafe channel position is not being passed to the stabilization system on these two devices.

Kreisflieger commented 6 months ago

Hello mawzthefinn,

thanks a lot for your confirmation. Big question now:

How to address this missing function to FrSky. Do you have any contact to the firmware devs, or can Bertrand help ??

Regards Stephan

github-actions[bot] commented 3 months ago

This issue is stale because it has been open 90 days with no activity. Remove stale label or comment or this will be closed in 30 days.

Kreisflieger commented 3 months ago

Please unstale, the automatic mode is a still missing basic function of a stabilization device. ( receiver and RB's )

Kreisflieger commented 2 months ago

Hope, the RF team will now take care about this issue.