Suggestions

[retrohospital]

Hi there, Thanks for your software which I like very much and use with my GW on a dual floppy setup

Here are a few suggestions, from a regular user

• We should be able to set a few settings "once and for all" (in the "options" ?) : in particular the number of drives, the way to adress them ( Shugart 012 or IBM drive A,B) and probably the COM port. It is for example dangerous to send commands to "Shugart 0" on a IBM cable (this would activate multiple motors).
• We should be able to add a flag on templates saying if they are valid for drive 0,1,2 or A,B (see above) this to avoid sending a 720KB floppy image on a 1.2Mb drive (which is probably not what you want)

Basically Device/COM and Drive should be an option (not a setting to change at each burn like now) and templates should incorporate a drive number/letter (eg 1.2MB can only go on drive A, 720K and 1.44 can only go on drive B, etc).

[FrankieTheFluff]

Hi retrohospital, ok, thank you for the ideas. I will have a look on them

Greetings Frankie

[ausfan]

Can we have an option for 0-76 on the number of cylinders for 8" disks? as they only have 77 cylinders so the 0-79 option hits the end stop.

[FrankieTheFluff]

@ausfan 😀 sure I could add. It's already possible to overwrite the text in the dropdown

Greetings