search

Freenove / Freenove_4WD_Smart_Car_Kit_for_Raspberry_Pi

Apply to FNK0043
Other
133 stars 148 forks source link

Some practical problems from Tutorial.pdf #17

Open Sognineibicchieri opened 3 years ago

Sognineibicchieri commented 3 years ago

Hi, some pratical problems on the Tutorial.pdf and components provided for the assembling. Page 72, step 9. Are you sure that M2.58 is the right size for the screw? The holes in the white plastic are too small, almost impossible to let go through the M2.58 screws. At the end, it took some efforts to let the screws go through, but really, M2*8 or even smaller screws would be great.

Sognineibicchieri commented 3 years ago

page 52, Install Pan Tilt on smart car board, step 2. To be consistent the installation of servo 1, should use M24 included in the package to fix servo 0 as for the servo 1. No need to use M210+Nut M2.

Sognineibicchieri commented 3 years ago

Page 54, Wiring. To be more practical, Wiring should be done before assembling the Pan Tilt. That is, page 54 should happen before page 51. It's hard, if not impossible to plug the wires when there's almost no space at all for the wiring. Same, Page 56 should be anticipated to right after page 54, because it would be very difficult to put the wires F/F straight as shown after attach again after the step 8 on page 51. And the image on page 56 is not complete. Better to straight the camera cable in a similar way to facilitate the connection later. Had to undo the step 8 on the page 51 to detach from the servos and redo the step 8 after wiring.

DenzelChen commented 3 years ago

Dear customer, Thank you so much for your detailed information. We will check them more carefully and update the tutorial. Sincerely, Freenove