Closed DaWingla closed 8 months ago
following... I'm currently running a BTT Kraken for my MCU and would like to see a configuration for this MCU
following... I'm currently running a BTT Kraken for my MCU and would like to see a configuration for this MCU
On which printer?
I run it in a voron 2.4
I run it in a voron 2.4
On which drivers did you connect the differents steppers? Because of the different max current of the TMC2160 drivers. Did you use the 3A for Z motors and the 8A for X,Y and E?
S1 and s2 are a and b and s5 6 7 and 8 are there z drives. Like the ldo 2.4 config.
I made an rough printer.cfg so that the printer works.larer I could post it
ok... can you check #476 ?
Ohh cool thank you .
PR merged in develop. It will be available on the next release :)
Describe the feature or hardware support you'd like
is the support of the BTT Kraken planed??
Additional context or information
No response