LDO_Nighthawk-SB Toolhead board config.

[mvdveer]

Describe the feature or hardware support you'd like

Support for LDO Nighthawk-SB board. I have done a mapping of the pins and included it in the attached config file as a .pdf as it won't upload as a .cfg file. I was going to add the file to the /config/mcu_definitions/toolhead section and reference it in the mcu.cfg file [include config/mcu_definitions/toolhead//LDO_Nighthawk_v1.0.cfg]

Additional context or information

[Phantastic1]

following... I'm currently running the LDO Nighthawk and would like to see a configuration for this setup too

[Surion79]

you are always welcome to take a config as template and provide a configuration via a pull request to speed up the process :)

[mvdveer]

you are always welcome to take a config as template and provide a configuration via a pull request to speed up the process :)

Here are the files in the correct directories in zip file format. LDO_Nighthawk-SB.zip

[Benoitone]

you are always welcome to take a config as template and provide a configuration via a pull request to speed up the process :)

Here are the files in the correct directories in zip file format.

LDO_Nighthawk-SB.zip

Why don't you do a PR?

[mvdveer]

you are always welcome to take a config as template and provide a configuration via a pull request to speed up the process :)

Here are the files in the correct directories in zip file format. LDO_Nighthawk-SB.zip

Why don't you do a PR?

As I had not done a Pull request before, I had to do some reading - sorry for the inconvenience, but it has been done. Created a new pull request.

[mvdveer]

you are always welcome to take a config as template and provide a configuration via a pull request to speed up the process :)

Thank you - have done a PR - posted

[Frix-x]

Everything is now done properly on #505 Please let me know if it's ok for you now :)