search

FuzzyBunnys / TurbopumpController

1 stars 1 forks source link

Board doesn't load #1

Open ismsanmar opened 8 months ago

ismsanmar commented 8 months ago

Hi,

I've tried to check your board, but it doesn't show neither on kicanvas or kicad. On kicad it says that there is an error and that there are not edges on the Edge.Cuts layer.

Greetings.

FuzzyBunnys commented 7 months ago

Hi ismsanmar, apologies for the lack of clarity on my end. I'm currently reworking the board, and don't have a finished version to put up. The schematics are reasonably complete, I'll add a note mentioning it's in progress, can I ask where you found the link just to make sure I don't miss the update?

ismsanmar commented 7 months ago

Hi Nicolas, and thanks for the response. I found it on the fusor forum. I recently bough a Stainless Steel TMP 50 off eBay, without controller, and I was in search of a diy controller for it and stumbled on your thread on Google.

And about the price of the transformer, you should check your local suppliers. Here in Spain, I can buy a toroidal (built on Spain, not on china and them imported) with 2 35V outputs and 160VA for 35€, including shipping. Surely, on Canada you have better options, but they are outside of the usual electronics components web pages.