Closed danbowles closed 7 months ago
I want to make sure I am reading the guide correctly:
Also, does the switch go one the same side as the hot-swap sockets/promicro, etc?
Many thanks!
Neevermind; Sorted it. I soldered the two outer pads and 2 of the inner pads.
My issue before was when I soldered the 3 pads with too much solder I think and the board was in a "perma-reset" state of sorts :).
I want to make sure I am reading the guide correctly:
Also, does the switch go one the same side as the hot-swap sockets/promicro, etc?
Many thanks!