Make Screw molding and Fluid recycling equivalent

[LazyFleshWasTaken]

Your GTNH Discord Username

LazyFlesh

Your Pack Version

2.7.0 beta 2

Your Proposal

Make Screw molding and Fluid recycling equivalent. To fluid solidify a screw, you need 18L, however you only get 16L back from recycling it in a fluid extractor. Where are these 2L going?

Your Goal

Make it make sense /j

These should be equivalent. There is no loss that can be assumed, like in bolt to screw, so the discrepancy doesn't make sense.

Your Vision

Equivalency. It would also open an optional, but small save of material if you make casting it 16, or would recycle better if extracting is made into 18.

Final Checklist

• [X] I have searched this issue tracker and there is nothing similar already. Posting on a closed issue saying I like this change please reconsider adding it will prompt us to investigate and reopen it once we confirm your report.
• [X] I understand this change request may not attract enough attention and thus not be implemented.
• [X] I understand this change request may be rejected due to other community members think it's inappropriate.
• [X] I believe this feature would make the pack better.

[chochem]

pretty sure the 18->16 is meant to be a slight loss when lathing your bolt to a screw. Doesnt make much sense for solidifier though I guess. hmm.

[LazyFleshWasTaken]

Now that i think about it, there's a precedent in the Rotor recipe, for an alternative recipe that gives a small discount. Extruder uses 5, assembler and solidification use 4.25.