search

Gathiyo / arducopter

Automatically exported from code.google.com/p/arducopter
0 stars 0 forks source link

MP reports "mode unknown" for POS Hold #440

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
Arducoper NG or ACM?
ACM 2.6  MP 1.1.96

What steps will reproduce the problem?
1.Setup pos_hold as one of the flight modes.
2.Switch to pos_hold anytime MP is connected.
3.MP says "mode unknown". The copter is doing the right thing though.

What is the expected output? What do you see instead?
MP to report " mode changed to position hold" and display position hold on the 
HUD.

What version of the product are you using? On what operating system?

Please provide any additional information below.

Original issue reported on code.google.com by mrpi...@gmail.com on 7 Jul 2012 at 7:35

GoogleCodeExporter commented 8 years ago 
Still an issue in MP 1.2.31.
Toy gives the same
OF_Loiter shows Stabilize

Original comment by Benny.Si...@gmail.com on 20 Jan 2013 at 12:29

GoogleCodeExporter commented 8 years ago 
Closing all issues on the old issues list by marking them WontFix.

If this is still a valid issue please re-raise it on the new GitHub issues 
list: https://github.com/diydrones/ardupilot/issues

Thanks!

Original comment by rmackay...@gmail.com on 21 Jul 2013 at 2:14