search

Geeetech3D / Smartto-IAR

3D printer firmware and hardware of for stm32
11 stars 14 forks source link

E180 Does not print gcode created by slic3r #12

Open SonOfSardaar opened 5 years ago

SonOfSardaar commented 5 years ago

I sliced a calibration cube from sli3r and gave it to E180. When i started the print it will heat up the nozzle and nozzle will go to the bed but then there are 3 beeps and nozzle goes to home and lcd says 100% done.

This is not the case when i slice using cura. but the first file sliced by slicer works fine in A30 printer

macasero commented 5 years ago

I can confirm. E180 doesn´t print from slic3r PE. Same gcode DOES print on a A30 (using only a 130x130 bed size area)