GijsTempel / care-up

CareUp Game
0 stars 0 forks source link

Protocol: Measuring bloodpressure #1964

Open Mbaarda opened 1 year ago

Mbaarda commented 1 year ago

(0) Begroet de cliënt. Greet the cliënt.

(0) Pas handhygiëne toe. Apply handhygiene.

(1) Leg de benodigdheden binnen handbereik. Place the needed items on the workfield

(2) Plaats de bloeddrukmeter zo dat de waarden op het afleesvenster goed zichtbaar zijn. Position the blood pressure monitor so that the readings on the display are clearly visible.

(3) Vraag de cliënt te gaan zitten en aan welke arm je de bloeddruk moet meten. Ask the client to sit down and on which arm to measure the blood pressure. Or check this in the file._

Extra Theory: Vraag de cliënt dikke en/of knellende kleding van de bovenarm te verwijderen. En Zorg dat de cliënt ontspannen kan zitten.

(4) Zorg dat de onderrand van de manchet ongeveer 2 cm boven de elleboogplooi zit. Make sure the bottom edge of the cuff is about 2 cm above the elbow crease..

image.png

Extra theory: Zorg ervoor dat de pijl op de manchet richting de hand en het midden van de elleboogplooi wijst. (5) Sluit de manchet met het klittenband. Zorg ervoor dat de slangen vrij liggen. Close the cuff with the Velcro. Make sure the hoses are free.

(6) Vraag de cliënt de onderarm op tafel te laten rusten met de handpalm naar boven gekeerd. Ask the client to rest the forearm on the table with the palm facing up.

(7) Het midden van de manchet moet zich ter hoogte van het midden van het borstbeen bevinden. Dit is ongeacht de positie van de cliënt. The center of the cuff should be level with the center of the sternum. This is regardless of the client's position.

image.png

(8) Schakel de bloeddrukmeter aan volgens de gebruiksinstructie, om de meting te starten. Switch on the blood pressure monitor according to the instruction manual to start the measurement.

(9) De pomp begint de manchet op te blazen, waarbij op het afleesvenster de oplopende druk te zien is. The pump will begin to inflate the cuff, with the display showing the increasing pressure.

(10) De pomp stopt normaliter bij 190 mmHg met opblazen. De druk zal dan geleidelijk beginnen te zakken. In de tussentijd meet de automatische bloeddrukmeter de bloeddruk en hartslag van de cliënt. The pump will normally stop inflating at 190 mmHg. The pressure will then gradually begin to drop. In the meantime, the automatic blood pressure monitor measures the client's blood pressure and heart rate.

(11) Aan het eind van de meting klinkt er een lange pieptoon. De lucht in de manchet loopt er nu snel uit. At the end of the measurement, a long beep will sound. The air in the cuff will now run out quickly.

(12) Zodra de waarden op het afleesvenster verschijnen, is de bloeddrukmeter klaar met meten. As soon as the values appear on the display, the blood pressure monitor has finished measuring.

(13) Lees de waarden af en noteer ze. Read the values and write them down.

(14) Herhaal na 1 tot 2 minuten de stappen 8 t/m 13. Herhaal de meting een derde maal bij een onregelmatige hartslag. After 1 to 2 minutes, repeat steps 8 to 13. Repeat the measurement a third time if the heartbeat is irregular.

(15) Stel de bloeddruk vast door het gemiddelde van de metingen te berekenen. Determine blood pressure by calculating the average of the readings.

(16) Verwijder de manchet Remove the cuff.

(17) Ruim de materialen op.Clean up workfield

(18) Pas handhygiëne toe. Apply handhygiene

(19) Noteer de waarden, de arm waaraan gemeten is, de houding en eventuele verdere bevindingen. Record the values, the arm that was measured, the posture and any further findings

Mbaarda commented 1 year ago

We need to think about what we want to do with steps 9 through 12. No actions are needed here but this info does neet to be visible somehow.