[Leia] Design supporting structure

[jbon]

The structure supporting the towers and hosting the fans has to be designed

[Gillou38]

@jbon I add 1st version of the structure with some indications, maybe it need some modification. I try to optimize quantity of material, but it made it more complex to built without hole.

Link to the file : https://github.com/Gillou38/Drying-open-source-solution/tree/master/02%20-%20Developing/Dryer%20Le%C3%AFa

[jbon]

@Gillou38 I created the 3DModel of the structure and made some drawings to explain the parameters. See here: https://github.com/jbon/Drying-open-source-solution/blob/master/02%20-%20Developing/Dryer%20Le%C3%AFa/README.md

By drawing the structure, I realized some parts of the structure you designed were redundant so I left them out (see red strokes on the figure). Please have a look at the result and tell me whether it fits your expectations.

I did not model the beams inside the drying chamber (see yellow strokes on the figure) because I am not sure how you want to attach the OSB panels to them to separate the drying columns. Do you have a idea how to do that?

[Gillou38]

@jbon I think the structure in 2 parts, maybe that's better to separate the 2 steps:

• 1st the exterior structure, supporting structure
• 2nd the interior structure, to fix drying columns and deshumidifier. So yellow and red strokes is only used to fix drying columns, it's like a set square but used to screw inside. The red strokes is redundant for the supporting structure, but they used to columns drying. The yellow stroke will be screw by the bottom, and the columns by the side.

I'm not sure to be clear. If you think about something better, you're welcome.