Large Material Press does not manufacture double plates

[KaxelOleg]

I have set the MetalBender mode and as I understand it, it does not require any chips at all to select a recipe. I play the Nomifactory GTCeu assembly and when I tried to create a double plate (any one), he gave me a regular plate if there is an ingot, and a foil if there is a plate. I chose the right chip for the manufacture of dual plates, but apparently it uses only the mode of ordinary plates.

[KaxelOleg]

I have set the MetalBender mode and as I understand it, it does not require any chips at all to select a recipe. I play the Nomifactory GTCeu assembly and when I tried to create a double plate (any one), he gave me a regular plate if there is an ingot, and a foil if there is a plate. I chose the right chip for the manufacture of dual plates, but apparently it uses only the mode of ordinary plates.

Oh, I removed all the chips from the additional ports with other configurations and left only the one where the dual plates are needed and it worked. I just thought that, depending on the port, he would use those chips that lie in that port, and not just one.

[KaxelOleg]

This problem is also observed with the extruder

[KaxelOleg]

This problem is also observed with the extruder

I think that if I start checking all the other machines, then I think they will also mix recipes, although there is no such thing with an assembly machine, thank God.

[KaxelOleg]

This problem is also observed with the extruder

I think that if I start checking all the other machines, then I think they will also mix recipes, although there is no such thing with an assembly machine, thank God.

I'm an idiot and didn't notice the most important button in the machine interfaces, now I understand, I'm sorry