search

Guizz27 / Marlin---Longer-LKx-Pro

Marlin 2.0/2.1 for Longer LKx Pro. Should also work with Alfawise U30 Pro
http://marlinfw.org
GNU General Public License v3.0
38 stars 15 forks source link

Enable RUNOUT_DISTANCE_MM 25 in Configuration.h #12

Closed jgbrown54 closed 2 years ago

jgbrown54 commented 2 years ago

An ongoing issue with Longer is false Runout detection. Marlin has enabled this option to allow a longer period before action is taken. It basically says that when a Runout is detected, don't take action unless 25mm of filament has been extruded. If the condition is cleared before the 25mm is extruded, no action will be taken and the counter will be cleared. This will prevent noise caused by longer wires to the sensor and momentary detections caused by filament diameter errors of less than 25mm. Actual filament runout will still occur. It will just be slightly delayed.

Guizz27 commented 2 years ago

Currently integrating Marlin 2.0.9.4 and 2.1. I will enable this be default.

Guizz27 commented 2 years ago

This is turned on in the new release 2.0.9.4 GC 1.1.