Hey @COBrogan I fixed the error you observed the other day such that any element that uses the "new" method odf moe sophisticated discharge equations and lists will automatically send their process water to the local stream. You may recall your observations was that the local process water was identified as separate from other streams, but then going nowhere in these new setups. Though, I'll not that the process water fraction defaults to 0.0, so there was no actual loss of water in the previous setup unless we had set the process race to > 0.0 (and it may be that this is totally unused, but we should cetainly pay attention to it when we configure models going forward).
Hey @COBrogan I fixed the error you observed the other day such that any element that uses the "new" method odf moe sophisticated discharge equations and lists will automatically send their process water to the local stream. You may recall your observations was that the local process water was identified as separate from other streams, but then going nowhere in these new setups. Though, I'll not that the process water fraction defaults to 0.0, so there was no actual loss of water in the previous setup unless we had set the process race to > 0.0 (and it may be that this is totally unused, but we should cetainly pay attention to it when we configure models going forward).