Create Sensor Entities - Githubissues

HASwitchPlate / openHASP-custom-component

Home Assistant custom component for openHASP

https://www.openhasp.com

MIT License

51 stars 12 forks source link

Create Sensor Entities #2

Open dgomes opened 3 years ago

dgomes commented 3 years ago

Create sensor entities for Landon L8 status information (e.g. wifi rssi)

nagyrobi commented 3 years ago

Also prepare for temperature sensor which is built-in (not yet in firmware). I intend to replace completely with some I2C sensors.

dgomes commented 3 years ago

currently that information is an attribute in the plate entity

nagyrobi commented 3 years ago

That's more than enough so far

fvanroie commented 3 years ago

How about the Wh energy sensor in the Lanbons?

nagyrobi commented 3 years ago

Temperature more important, for the sensor which is physically there on them. One wants to know the room temperature better, rather than what's the actual consumption of a bulb on the ceiling... The factory firmware supports it, and it has an option to set an offset value for it.

fvanroie commented 3 years ago

The energy sensor is working, the temperature sensor is not...

nagyrobi commented 3 years ago

Common sensors (mostly config independent):

Network status connected/offline (binary, sensor_class: connectivity) (note this sensor should never be unavailable!)
Plate uptime (seconds)
WiFi RSSI (only with wifi, ESP32 with ethernet module should skip this)
WiFi signal strength (only with wifi, ESP32 with ethernet module should skip this)
Device free memory (Heap, Block) (KiB)
LVGL free memory (percentage)
PSRam free (percentage)
Idle state (text: short/long/off) - easier in automations, less templating