Open xxxajk opened 2 years ago
machine_start_gcode
machine_end_gcode
wall_line_count
(wall_thickness / machine_nozzle_size)
retraction_distance
retraction_retract_speed
retraction_prime_speed
retraction_extra_prime_amount
retraction_minimum_travel
maximum_retraction_count
That said, here are the parameters with consideration as to the above bugs.
./extcuraengine slice -l ~/Torus.ast \ -o ~/out.gcode \ -s machine_width=160 \ -s machine_depth=160 \ -s machine_height=100 \ -s machine_nozzle_size=0.5 \ -s material_diameter=2.85 \ -s outer_inset_first=False \ -s infill_sparse_density=100 \ -s layer_height=0.25 \ -s wall_line_count=2 \ -s support_enable=False \ -s top_bottom_thickness=1.0 \ -s infill_line_width=0.5051 \ -s speed_infill=3600 \ -s speed_layer_0=900 \ -s speed_travel=10500 \ -s speed_wall_0=900 \ -s speed_wall_x=1800 \ -s machine_start_gcode=";\n" \ -s machine_end_gcode=";\n"
You have the .AST to test on that I gave you. --Cheers!
added a flavor, so that marlin gets it's mm/min, instead of mm/sec.
machine_start_gcode
andmachine_end_gcode
do not work. Perhaps these should be plain text files, as discussed.wall_line_count
should be able to be adjusted for with(wall_thickness / machine_nozzle_size)
, if given, instead of count.retraction_distance
normally 1.75mmretraction_retract_speed
normally 10mm/sretraction_prime_speed
normally 10mm/sretraction_extra_prime_amount
normally 0retraction_minimum_travel
normally 1mmmaximum_retraction_count
normally 90That said, here are the parameters with consideration as to the above bugs.
You have the .AST to test on that I gave you. --Cheers!