I would like the ability to print out everything I can in standard gridfinity units (u) and then seperately print out the buffer pieces.
So essentially in a situation that is slightly larger than a 4x4 grid I could print out
1x 4x4 Baseplate
Depending on wanting it centered vs corner justified
2 or 4 Buffer Pieces that look like a mostly cut away gridfinity 1U piece.
In this way I can reuse the 4x4 baseplate if I no longer use this drawer without wasting a lot of filament on a larger piece that has only a very specific use case.
This may be something that has to be developed in the OpenSCAD library instead.
I would like the ability to print out everything I can in standard gridfinity units (u) and then seperately print out the buffer pieces.
So essentially in a situation that is slightly larger than a 4x4 grid I could print out 1x 4x4 Baseplate Depending on wanting it centered vs corner justified 2 or 4 Buffer Pieces that look like a mostly cut away gridfinity 1U piece.
In this way I can reuse the 4x4 baseplate if I no longer use this drawer without wasting a lot of filament on a larger piece that has only a very specific use case.
This may be something that has to be developed in the OpenSCAD library instead.