What steps will reproduce the problem?
1.Connect to K3
2.Go to any freq. any mode, except DIGL / DIGU
3.Switch mode to DIGL or DIGU
The frequency of the K3 goes to the upper freq. limit 54MHz and toggles
every few seconds between the lower freq. limit (500kHz) to te upper limit
(54MHz). It stops when any other mode is selected.
What version of the product are you using? On what operating system?
PowerSDR/IF v. 1.19.3.5 - Windows XP SP3 on Laptop SL500, Thinkpad / Dual core
processor - 4 GB RAM - K3 transceiver - LP Bridge 1.0.8 The K3 is connected
directly to the LP Bridge via an USB / RS232 converter cable to the K3 COM port.
Please provide any additional information below.
This only happens when the K3 is connected (START lights up blue)
It also happens when I switch mode on the K3 to TX Data
Note: I have a new computer with Windows 7 and Intel core I5, but did not yet
install the software to see if this resolves the issue.
Original issue reported on code.google.com by XV1X.Vie...@gmail.com on 31 Oct 2013 at 2:42
Original issue reported on code.google.com by
XV1X.Vie...@gmail.com
on 31 Oct 2013 at 2:42