I was comparing the reported data using this great dummycloud software with the data I get via deye-inverter-mqtt. At least with the firmware 1.57 it seems that the faster reporting configured via AT command is not providing more measurements but just re-sending the same measurement more often.
If anyone else can confirm my observation, it might be worth to mention it in the README. I really like the dummycloudsolution anyway, just wanted to set right expectations.
I was comparing the reported data using this great dummycloud software with the data I get via deye-inverter-mqtt. At least with the firmware 1.57 it seems that the faster reporting configured via AT command is not providing more measurements but just re-sending the same measurement more often.
If anyone else can confirm my observation, it might be worth to mention it in the README. I really like the
dummycloud
solution anyway, just wanted to set right expectations.In the below diagram you can see the two in comparison, showing that the data from dummycloud is also only changing about every 5 minutes.