Closed arnoakavdb closed 1 year ago
There are 3 resistors on the board, all of which are connected to LEDs. The value of these resistors will depend entirely on what SMD LEDs you pick.
Use the datasheet for your chosen LED and fill in the figures on this website to determine the value of the resistor required
ok so if i want to put smd white led is that correct?2Ohm
a 1000mA LED seems very high - usually white I expect to be around the 60mA mark, but otherwise, yes, if that's what it says go for it.
Realistically you could use a 510ohm, 1k, 10k, etc - it will just reduce the brightness depending on the value.
Hi, thanks for the board. i order the multitool board to test the power of the flipper but i'm a bit confused with resistor.are they 0 because i can't see any data for them. Thanks in advance