Trigger signal inputs on transmitter need additional pull-up or pull-down resistors.

IRNAS / ToslinkCNC

CNC machine control modules with Toslink optical cables

Other

25 stars 11 forks source link

Trigger signal inputs on transmitter need additional pull-up or pull-down resistors. #4

Closed MatejGomboc closed 8 years ago

MatejGomboc commented 8 years ago

Trigger signal inputs on transmitter need additional pull-up or pull-down resistors. It is an issue only if transmitter board is disconnected from Arduino, Raspberry PI or Planet CNC controller.

MatejGomboc commented 8 years ago

Arduino shield has been updated. Pull-down resistors for Trigger1, Trigger2, Trigger3 and pull-up resistor for Enable were added.

Corrected in revision c65eda3, committed on Jun 1, 2016.