Open ghost opened 3 years ago
Check if the 25Hz mode is activated - that only works on M9N GPS modules.
I have a BN-220, so it’s a m8q module.
That one doesn't support 25Hz either
So, I stay on the 86.xx version or I change my gps to move to the earlier version ?
You can upgrade to the latest version just make sure the 25Hz mode is turned off.
Thanks but already tested with no result. So i prefer staying with the 86.xx version who work perfectly… Sometimes I’m trying new releases, but no one work at this time.
When you change to 10Hz you need to make sure you save and then power cycle.
Ok; I’ve tried this and I have the coordinate into the fpv mask but when I discover new sensors on the tango 2, she see everything except the gps.
What version are you running ImpulseOSD/KISS FC?
The last one for both; so I think it’s 92.xx for impulse and 46.xx for kiss
Hello, it’s very strange : When i’m running the 86.12 firmware, the GPS works fine, but when i’m updating to the 90.xx or earlier, GPS doesn’t work again.
Any idea ?
Thanks for your help.