Review Actions - Githubissues

[x] fix footprints of capacitors C707&C717, C709&C71, C713&C718. The footprint is identical but different in the pads
[x] redraw U701 and U702 symbol showing 1213 and 78
[x] make units consistent either 0.1uF or 100nF. Let us go with uF
[x] For R20 & R21, change the values to reduce the unique part count by 1. The 22k can be changed to 10k, and the 47 can be something around 21.3k (=47k/22k)
[x] Mark R12 as DNP and leave Q4A (Default setup)
[x] Make R1 470 Ohm
~Change values of R701, R703, R706, and R707 to match the desired voltage but also fit other resistor values like 100k~
[x] Add a switch to J601 (ext wakeup) but DNP as addition to wake up on press or external event, SKRKAEE020.
[x] Remove 0805 and 0603 text comments from the schematic and choose the footprint
[x] Remove VIN from MCU sheet including the tracks because it is unused
[x] Mark screw-terminal on charger IO sheet as DNP and remove JST connector (misplaced)
[x] Hide PWR_FLAG label
[x] Change R1, R19, R22 to 470 Ohm
[x] Hide value fields of JP1 and JP2
[x] Remove the labels CHREN, CHR0 and CHR1 and place TestPoints for them
[x] connect 5V_EN and 3v3_EN also to the pinheader
[x] Rename Labels: Vin on charger-io sheet to 3v3_RTC
[x] discuss ORing circuity (@2010019970909 and Seth)

[x] Move images from the Charger sheet into a ReadTheDocs Page, only keep formulas as text
[x] finish the SMBALTERT LED circuit with LED and resistor value
[x] Attach SMBALERT track to the pin 32 of the MCU
[x] Dump R4 and R5 and use 3-way-solder-jumper for JP1 and JP2 with a cutting track
[x] Max cell count is LTC4162L, we should change the posibilities of the board to match that. Remove JP2 and R5
[x] Unify R11 and R7
[x] Replace NTC Resistor with a 10k value one (as default)

last step to not loose references from review:

Informaticore / SuperPower