first I want to thank you for this awesome project.
I adopted everything for my "Sidewinder" (in my case I would call it a "Sideoron" :D) for the afterburner printhead with your galileo extruder.
Yesterday I was able to change the toolhead from my previous one to my new one with your galileo extruder.
Unfurtunately I can't get any right extrusion out of it :( If I reduce my retraction length to 0.25mm then I was able to get this result:
With 0.75 or 1mm it will be a mess at all. Like this:
I guess something isn't working with the gears as expected and because I can't take a look inside of it while it is printing I don't know where to start with debugging.
I did the extrusion calibration for the rotation distance and the extruder was extruding the right length, it seems to only be affected when I'm doing prints with retracts :/
Heya @JaredC01,
first I want to thank you for this awesome project. I adopted everything for my "Sidewinder" (in my case I would call it a "Sideoron" :D) for the afterburner printhead with your galileo extruder.
Yesterday I was able to change the toolhead from my previous one to my new one with your galileo extruder. Unfurtunately I can't get any right extrusion out of it :( If I reduce my retraction length to 0.25mm then I was able to get this result:
With 0.75 or 1mm it will be a mess at all. Like this:
I guess something isn't working with the gears as expected and because I can't take a look inside of it while it is printing I don't know where to start with debugging.
I did the extrusion calibration for the rotation distance and the extruder was extruding the right length, it seems to only be affected when I'm doing prints with retracts :/