Repository for working with and improving the PCB design and production process available to students and faculty on Colorado Mesa University Campus, for the University of Colorado Boulder partnership program.
1
stars
4
forks
source link
Sometimes autoplacement does not place components when following the process guide #2
Some students reported not being able to autoplace components in the PCB editor after moving from the schematic.
Need to test and verify, suspect permissions issues or perhaps project configuration.
Address this in the process readme.
This likely occurs because the PCB Editor needs to update from the Schematic Editor (hotkey "F8").
This should run a checker and will report any warnings or errors as well as provide the option to replace existing footprints.
Jbsco
commented
11 months ago
Some students reported not being able to autoplace components in the PCB editor after moving from the schematic. Need to test and verify, suspect permissions issues or perhaps project configuration. Address this in the process readme.