Docs Feedback - Mr. Snow Makes

[JeffreyRodriguez]

• [ ] Printed Receiver instead of Frame_Receiver
• [x] Missing Foregrip.stl
• [x] Add link to assembly STLs.
• [x] Stock pin retaining pin section is unclear.
• [ ] Add note about notching pin
• [ ] Trigger docs outdated, references "glued sides"
• [x] Firing pin could use some pictures and fleshed out details
• [ ] A vitamin reference in the instruction line would be nice instead of having to flip back to reference sheet.
• [ ] Or on vitamin sheet make a box to place the part on the paper as a priming area!
• [ ] Even the vitamin descriptions don't precisely match the kit... like sear spring in kit seems to be 40mm long instead of listed 35mm?
• [x] When reaming holes in plastic with drill bit I run the drill in reverse. I don't want drill cutting overaized
• [ ] Had installed the disconnector.
• [ ] Chamfered the FP tip with OD chamfer bit
• [ ] Add links to Liberator12k Library videos.
• [ ] Add OpenSCAD tour video
• [x] Indicate nail head against buttpad for rear pin retention
• [x] Recommend adhesive for firing pin nail
• [x] Clearer pictures of firing pin assembly/FCG_Housing
• [ ] Indicate use of washers in instructions for clarity
• [ ] Discuss pic rail options.
• [ ] Is there a printable picatinny sight rail?

[Mr-Snow-Makes]

Today's suggestions. Indicate nail head against buttpad for rear pin retention, recommend adhesive for firing pin nail, would like clearer pictures of firing pin assembly FCG_Housing, indicate use of washers in instructions for clarity.

Is there a printable picatinny sight rail? also is the aesthetic barrel shroud available?

[Mr-Snow-Makes]

Possible revision for the future would be a return spring for charging handle. The floppy nature I'm seeing when cocked doesn't feel polished?

[rotorit]

Maybe add some "fine tuning" parameters to the hammer and hammer tail to make it easier to fit various firing springs(if not already done)

• In stead of "hammer spring clearance" maybe something like "Hammer spring diameter " (compressed state ). Or add a new parameter for this in addition to said parameter.
• length of spring
• spring depth inside hammer
• option to choose hex nut for hammer bolt nut

[rotorit]

Maybe make it optional to add the front sight post to the base by splitting it to a separate part and make it possible to add it by dovetail slot or something similar?