KUTTHA / lamecraft

Automatically exported from code.google.com/p/lamecraft
GNU General Public License v2.0
0 stars 0 forks source link

Can't swim all the way up water #46

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago
What steps will reproduce the problem?
1. Create a very tall tower of water bricks.
2. Stand into it and hold/press select.
3. Glide up only a short distance and not reach the top.

What is the expected output? What do you see instead?
 Instead of swimming to the top of the tower like in Minecraft, you only go up a short distance then fall back down. If you hold select you will repeat this process over and over and never make any progress.

What version of the product are you using? On what operating system?

Lamecraft rev. 115, PSP-2000 Series, GEN 5.50D3 

Please provide any additional information below.

Original issue reported on code.google.com by benjamin...@hotmail.com on 29 May 2011 at 4:12

GoogleCodeExporter commented 8 years ago
+1 LameCraft op-30. 
You only swim up to around halfway of a water tower.
Suggest make it to swim to top of tower since water blocks are convenient way 
to do "portal tubes" in a big building.
Well the simple solution would be to make the portal water tube extremely tall 
(i.e sticking out of the building's ceiling), but it wouldn't look nice lol

Original comment by morrn...@gmail.com on 10 Jul 2011 at 8:51

GoogleCodeExporter commented 8 years ago
EDIT: After some testing it appears that it's a swim height limit problem
i.e no matter how high you build a water tower you'll only swim to a certain 
height.

Original comment by morrn...@gmail.com on 11 Jul 2011 at 11:25

GoogleCodeExporter commented 8 years ago
That is real cool. I'm watching this project closely. Starred. Good luck. Hope 
I didn't above the revision section.

Original comment by petrussijsma on 12 Jul 2011 at 8:51

GoogleCodeExporter commented 8 years ago
Accepted, known bug, will look into this.

Original comment by bfh...@gmail.com on 19 Jul 2011 at 6:02