Wiring documentation is not correct for Serial lines from Pixhawk to MKRZero

[KenLagoni]

The documentation incorrectly state: Pixhawk TX-> MKZzero pin 8 (RX) Pixhawk RX<- MKZzero pin 9 (TX)

But instead it should be: Pixhawk TX-> MKZzero pin 13 (RX) Pixhawk RX<- MKZzero pin 14 (TX)

[mohanbabi]

@KenLagoni sir, it is better to change the diagram, sir. That is my opinion.

Thank you Sir

[KenLagoni]

@KenLagoni sir, it is better to change the diagram, sir. That is my opinion.

Thank you Sir

Yes that is what is says, the documentation must be updated (the diagram). :-)

[KenLagoni]

Solved, thank you @mohanbabi :-)

[mohanbabi]

thank you sir