Add SMA_Samtec_SMA-J-P-H-ST-EM1_EdgeMount model

[bitglue]

Work is my own, done with FreeCAD, based on the mechanical drawing at http://suddendocs.samtec.com/prints/sma-j-p-x-st-em1-mkt.pdf

Some of the dimensions aren't specified in the drawing so I guessed. I don't have this particular connector but a very similar one so I wasn't able to measure.

---

Thanks for creating a pull request to contribute to the KiCad libraries! Remember you must be the legal owner of the 3D model! Models downloaded from a manufacturers website cannot be accepted.

To speed up integration of your PR, please check the following items as you complete them:

• [x] A screenshot of the model(s) aligned with KiCad footprint(s)
• [x] Source files are contributed on the apropriate location
  • Link to the package3d-source pull request or to the script pull request
• [x] Step model submitted in 1:1 scale
• [x] WRL model submitted in 1:2.54 scale
• [x] 3D model alignment checked against KiCad footprint
• [x] WRL model uses correct material properties
• [x] Geometry check performed on the model

---

Be patient, we maintainers are volunteers with limited time and need to check your contribution against the datasheet. You can speed up the process by providing all the necessary information (see above).

[CLAassistant]

All committers have signed the CLA.

[bitglue]

I guess "Geometry check performed on the model" means Part -> Check Geometry in FreeCAD? If so, did that. If not, please link instructions and I'll be glad to do.

[bitglue]

A couple shortcomings I know of:

• the geometry of the threads is not exactly right. I'm no mechanical engineer and researching exactly what the geometry should be seemed like too much work.
• chamfers and a few similar details are omitted. I figured they'd just slow down rendering.
• it looks like this connector is designed for an interference fit: the center pin protrudes down a little lower than the legs that sit on top of the board. I also wasn't sure exactly what board thickness to expect, so the Z axis positioning is just eyeballed.

[bitglue]

@aris-kimi if you wouldn't mind reviewing this model also