search

KimJorgensen / easyflash

Fork of https://bitbucket.org/skoe/easyflash
http://skoe.de/easyflash/
41 stars 11 forks source link

USB not working #6

Closed DanHolli closed 5 years ago

DanHolli commented 5 years ago

I've been having trouble doing much with the USB interface, I'm not sure if this is the best place, but it is the only place I know of that is still active for this hardware. It is the most recent "official" version of firmware 1.1.1 I believe it is.

I can get a small program through by spamming the command line commands done by having it entered and run pressing control+c to kill it if it doesn't go, then pressing up and enter to quickly re-enter the command and run it and repeating that untill it goes.

anything larger or more complex just won't work, I can't write a disk image, nor can I flash CRTs.

I have all the jumpers in the data positions and untill I get my SD2IEC running again or the new one arrives, I'm stuck with the USB interface

KimJorgensen commented 5 years ago

I can only offer general advice: Do not use a USB hub, try a different USB cable, try a different PC. If you are looking for support, I would try lemon64 or forum64. Forum64 is German, but most seem willing to answer in English.

DanHolli commented 5 years ago

OK, thank you for the help, I'll try there later.

I've never used a hub, tried several cords, and used 3 computers, could just be old or corrupted firmware, I'll install your firmware when I get my SD2IEC running again.

KimJorgensen commented 5 years ago

Sounds more like a hardware issue to me, maybe a bad solder joint? Good luck