search

KipK / Ghettostation

Multiprotocol antenna tracker and ground osd.
144 stars 69 forks source link

servo test #7

Closed lucafedechen closed 10 years ago

lucafedechen commented 10 years ago

Hi Kipk.. Only for report Servo test not work...when enter in config...servo test...the lcd freezen and no button respond any more...not exit to main menu Thank you Best regards

KipK commented 10 years ago

You probably have something wrong somewhere. Servo test works, but it's quiet a basic feature. You can't do anything while servo test is running, it's normal it's just a dirty loop. I should take some time to clean it one day I'm agree :) You will regain control at the end, it should take a minute or 2. I have not coded any way to exit it yet.

But if servo don't move means there's something wrong in the setup. Have you configured the servo in the menu before trying the servo test ? All min/max values are set to neutral by default to avoid burning servos in endpoints so servo test shouldn't move when you try it while GS is not configured yet.

lucafedechen commented 10 years ago

Thank you Kipk....I use a old ardupilot board and my pin configuration wrong..double check all and now is working.. As you say after 2 minutes regain control and exit to main menu Thank again for your's response Regards

KipK commented 10 years ago

I've pushed a new test servo on the git, now you can quit when you want, the function is not blocky anymore.

lucafedechen commented 10 years ago

Thank you KipK