Open the-robo opened 2 years ago
Spring.scad Please add a feature to allow for the ends of the spring to rest on a flat surface.
Although not my use case, the best example I can think of is the springs under the bed of a 3D printer (or perhaps the replacement springs.)
As it stands (no pun intended) the spring will fall over if stood on one end.
I agree that would be better - I'll think about it and how to taper the ends of the flat section of the coil
Spring.scad Please add a feature to allow for the ends of the spring to rest on a flat surface.
Although not my use case, the best example I can think of is the springs under the bed of a 3D printer (or perhaps the replacement springs.)
As it stands (no pun intended) the spring will fall over if stood on one end.